ELECTRICAL SYSTEMS TROUBLESHOOTING (CONT)
(Sheet 2 of 7)
PROBLEM NO. 25 (CONT)
QUESTION OR INSTRUCTION
Make sure DK G wire harness connector behind LHIP is com-
Check fuse (NOTES E and F). Is fuse good?
If new fuse blows, go to Step 3.
Replace fuse (use 10 amp fuse only).
Gain access to rear of LHIP. Is voltage present (NOTE B) at
switch terminal where PR wire connects?
Repair/replace 16 gage PR wire from fuseholder to switch.
Is voltage present at other wire on switch when switch is turned 7
Turn POWER switch OFF. Replace switch.
Go on to Sheet 3