TM 10-3930-641-20
COOLANT FILTER BASE ASSEMBLY REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 3)
LOCATION/ITEM
ACTION
REMARKS
1. Coolant filter canister (11)
Remove by unscrewing counterclockwise with
strap wrench.
2. Inlet (3), outlet (3)
a. Disconnect lines at fittings (2).
b. Tag for identification.
c. Cap lines.
3. Two capscrews (12), washers (13)
Remove from bracket.
and nuts (14)
1. Two capscrews (12), washers and
Install in bracket.
nuts (14)
2. Inlet (3), outlet (3)
Connect lines at fittings (2).
3. Coolant filter canister (11)
Install.
a. Wet gasket with coolant.
b. Screw canister clockwise onto base.
Tighten with strap wrench.
Check and fill as required.
4. Coolant level
Go on to Sheet 3
2-245