TM 10-3930-641-20
(Sheet 3 of 3)
STARTING MOTOR REMOVAL/INSTALLATION (CONT)
REMARKS
ACTION
LOCATION/ITEM
Remove. Remove top capscrew last.
9. Capscrews (9)
Lift out of vehicle.
10. Starting motor
Position motor at flywheel housing.
1. Starting motor
Install and tighten three capscrews. Start top
2. Capscrews (9)
capscrew first.
Tighten terminal nuts to 16-30 lb. in. (2-3.5 Nm).
Connect. Be sure to reconnect them in the
positions marked before they were discon-
nected.
Position at side of engine.
4. Oil filler tube (6) and gasket
Install and tighten two screws.
.5. Capscrews (4)
Install.
6. Capscrew and upper clamp
Install in clip (3).
7. Capscrew, washer, and nut
a. Position on frame.
8. Panel (1)
b. Install four capscre ws, washers and nuts
Black - Top
(2) holding panel to frame.
Red - Center
Dark Blue - Lower
c. Connect wiring harnesses to back.
End
2-260