TM 10-3930-641-20
BRAKE PEDAL LINKAGES DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 5 of 5)
LOCATION/ITEM
ACTION
REMARKS
1. Lower cable housings (14)
a. Install cm bracket.
b. Secure with nuts (11).
2. Middle cable housings (13)
a. Install on bracket and to floor plate.
b. Secure with nuts (8).
Install.
3. Capscrew (9), nut., washer and clip
(10)
a. Feed through cable housings from brake
4. Cable wire (4)
control valve end.
b. Secure to clevis.
c. Secure clevis to brake levers with pins (6)
5. Upper cable housings (12)
Install and feed cable wire (4) through at same
time.
6. Cable wire (4)
a. Secure to clevis.
b. Secure clevis to brake pedal with cotter
pin, two washers, pin (3) and spring (1).
7. Angle stop (2)
a. Install.
b. Adjust against brake lever pedal so that
pedal is 3.25 in. (82.6 mm) above pedal
stop on floor plate.
8. Two panels that cover brake pedal
Install and secure with capscrews.
linkage and cables.
End
2-357