TM 10-3930-641-34-1
WATER PUMP SPECIFICATIONS
(Sheet 1 of 1)
(1)
Torque for three long studs in
cylinder block ..................................... 20 + 3 lb. ft. (27 4 N.m)
Put sealer on threads of short stud in front housing.
(2)
Oil seal. Put engine oil on the seal lip. Assemble with the lip toward
(3)
Seal. Put a thin layer of engine oil in the bore for the seal.
(4)
Water seal and ring:
a. Put engine oil on the seal.
b. Install the seal and ring together in the housing bore, with the
shiny face of the ring outside.
(5)
Seal assembly:
a. Remove the spring from the seal.
b. Put engine oil inside the seal assembly.
c. Install the seal assembly around the shaft until the carbon face
makes contact with the shiny face of the ring (4).
d. Install the spring.
(6)
the impeller ......................................28 + 1 lb. ft. (38 + 1.4 N.m)
TA098828
2-98