TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING SPECIFICATIONS
(Sheet 1 of 2)
(1) Install dowel to get a dimension from centerline of
fuel injection pump bore to dowel (seal dowel hole with
aluminum ball) ........................................ .584 .002 in.(14.83 0.05 mm)
(2) Install pin to get a dimension of .......................................188 in. (4.78 mm)
(3) Install dowel to get a dimension of ................................480 in. (12.19 mm)
(4) The center of the bearing tab must be within .002 in. (0.05 mm)
of a vertical line that goes thru the center of the bearing and
parallel to vertical centerline of injection pump housing.
(5) Bearing joint must be within area "A" (30 to the left
of vertical) and oil hole must be in area "B." Install
bearing to get a dimension of ............................................19 in. (4.8 mm)
(6) Torque for bolts that hold fuel
injection housing............................................. 40 5 lb. ft. (54 7 N-m)
(7) Bearing joint must be within area "A" (30 to the left of
vertical) and oil hole must be in area "B." Install bearing
to get a dimension of ...........................................................04 in. (1.0 mm)
TA098840
Go on to Sheet 2
2-110