TM 10-3930-641-34-1
ENGINE FRONT SUPPORT AND TRUNNION REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 9)
LOCATION/ITEM
ACTION
REMARKS
1. Rear engine supports (change if necessary)
a. Remove mount assembly (1) from support
(2).
b. Install new mount assembly (1) on support (2)
until inner cup is tight against shoulder of
pin.
c. Make sure support (2) is installed with as little
space as possible between mount
assemblies and rear face of cylinder block.
NOTE
Make sure hydraulic supply line and hydraulic
pumps are aligned before lowering engine to its
mounts.
WARNING
Do not put an overload on ratchet puller when
engine and torque converter are being moved.
3-18