TM 10-3930-641-34-1
FUEL INJECTION PUMP HOUSING REMOVAL/INSTALLATION (CONT)
(Sheet 6 of 11)
LOCATION/ITEM
ACTION
REMARKS
2. Left fuel rack bearing.
Turn fixture assembly and aline dowels with
right fuel rack bore.
Follow same steps as for right bearing.
3. Front and rear camshaft bearing (51)
Install.
NOTE
Aline oil holes in bearings with oil holes in
pump housing.
Rear bearing must be installed so outer face is
0.19 in. (0.48 cm) from rear surface of pump
housing.
Front housing must be installed so outer face
is 0.04 in. (0.10 cm) from front surface of
pump housing.
4. Lip seal
Install with outside bearing (54) with lip
towards the outside.
5. Outside bearing (54)
Install with driver.
NOTE
Install bearing until the bearing face is 1.505 in.
(38.227 mm) from outer face of pump housing
face.
Go on to Sheet 7
3-52