CYLINDER LINER REMOVAL/INSTALLATION (CONT
(Sheet 5 of 7)
Cylinder liner (projection)
e. Check liner (projection) height with a liner
projection gage (6) at four locations
around the liner.
Liner projection height must be .005 +
.003 in (0.13 + 0.08 mm) The difference
between the four measurements on the
same liner must not exceed .001 in.
(0.03 mm) The difference between liner
(projection) height for liners next to each
other must not exceed .001 in (0.03 mm).
If liner is turned in cylinder block it can
make a difference in liner (projection)
Go on to Sheet 6