TM 10-3930-641-34-1
CAMSHAFT REMOVAL/INSTALLATION (CONT)
(Sheet 3 of 7)
LOCATION/ITEM
ACTION
REMARKS
6. Camshaft front plate capscrews (4)
Remove.
7. Camshaft assembly (5)
Pull approximately 2 in. (50.8 mm) out of the
cylinder block.
CAUTION
Camshaft rear gear must be securely
fastened with wire. If not, gear will fall into
flywheel housing when bolt (3) is removed.
Engine must then be removed to recover
gear.
8. Camshaft rear gear
Fasten to the flywheel housing with wire.
9. Bolt (3)
Remove from the camshaft rear gear.
TA099101
Go on to Sheet 4
3-275