TM 10-3930-641-34-1
TIMING GEARS REMOVAL/INSTALLATION (CONT)
(Sheet 4 of 6)
LOCATION/ITEM
ACTION
REMARKS
8.
Plug (11)
Remove from flywheel housing. (This is to
help make housing replacement easier.)
9.
Twenty-one flywheel housing
Remove.
capscrews (10)
10.
Flywheel housing
Remove. Check for cracks and pieces broken
out. Replace if necessary.
NOTE
Weight of the flywheel housing is 340 lb.
(154 kg).
11.
Flywheel housing covers (12)
Remove capscrews (14) and washers (13).
and (16)
Remove covers (12) and (16) with gaskets
(11) and (15).
INSTALLATION
1.
Flywheel housing covers (12)
Position covers (12) and (16) with new gaskets
and (16)
(11) and (15) onto housing. Secure with cap-
screws (14) and washers (13).
2.
Flywheel housing gasket
Position on cylinder block.
3.
Crankshaft rear wear sleeve, seal
a. Coat with clean engine oil.
b. Install.
4.
Seal pilot
Install in crankshaft rear seal.
Go on to Sheet 5
3-312