FLYWHEEL REMOVAL/INSTALLATION (CONT)
(Sheet 4 of 5)
1 Ring gear (2)
Lay flywheel flat on a work surface with
See specifications page 2-96 for detailed instructions.
ring gear groove up. Heat ring gear (2) evenly
until it will slide over flywheel boss.
Be sure ring gear seats fully onto shoulder (A)
2 Guide bolts (B)
Install in crankshaft.
To prevent injury, do not let flywheel (1)
fall off lifting arm (3) as it is being installed.
Weight of the flywheel is 96 lb. (44 kg.).
3 Lifting arm (2)
Fasten to hoist and install in groove of
flywheel as shown at right.
4 Flywheel (1)
Put in position on guide bolts (B).
Go to Sheet 5