TM 10-3930-641-34-1
CRANKSHAFT MAIN BEARINGS REMOVAL/INSTALLATION (CONT)
(Sheet 7 of 7)
LOCATION/ITEM
ACTION
REMARKS
9.
No. 3 upper main bearing
Install thrust plate (5) on each side.
NOTE
Thrust plates must be installed so that side
marked "Block Side" faces toward the
cylinder block.
NOTE
No. 3 main bearing is the only one that has
thrust washers.
10.
Nos. 2, 3 and 4 main bearing caps
a. Install.
b. Tighten cap bolts using procedure given in
8C thru 8h above.
11.
Nos. 1 and 5 main bearings
Install and check clearance following same
procedure used for Nos. 2, 3 and 4 main
TA099140
Go on to Sheet 7
333343
-- 43