TRANSMISSION ASSEMBLY (CONT)
Clutch housing No. 2 (cont)
Position housing on dowels, springs and
plate assembly as shown at right.
Be sure grease pencil mark on outside of No. 1
housing aligns with mark on outside of No. 2
housing, and the 12 springs are in their bores
in the piston of No. 2 housing.
d. Install long capscrews. Tighten to a torque
of 65-85 lb. ft. (102-115 N-m).
Sun gear (40)
Install onto output shaft (72).
Install in No. 5 clutch housing planet carrier
Go on to Sheet 15