TM 10-3930-641-34-2
TRANSMISSION OIL PUMP DISASSEMBLY (CONT)
(Sheet 4 of 5)
LOCATION/ITEM
ACTION
REMARKS
5.
a. Install in cover (8) until bearings are 0.062
in. (1.57 mm) below machined surface of
cover.
NOTE
Bearing seams should be 150 - 450 from
centerline through bearing bores and should
face toward oil outlet in cover.
b. Check that bearing bore is within
See Specifications, page 2-69.
specifications.
6.
Cover (8)
a. Turn over.
b. Install seal (10).
NOTE
Install seal until it makes contact with
counterbore in cover assembly. Lip of seal
must point toward splined end of drive gear.
c.
Coat lip of seal with clean SAE 30 oil.
7.
Preformed packing (19)
Install in body assembly (4).
Go on to Sheet 5
4-195