FRONT DIFFERENTIAL AND BEVEL GEAR REMOVAL (CONT)
(Sheet 3 of 4)
Brake tube assembly (2)
a. Disconnect from wheel.
Remove clip (1) that holds tube assembly
to axle housing.
Two capscrews (3) that secure
hydraulic lines to differential
Differential and bevel gear
Attach transmission floor jack.
Put a piece of bar stock between bottom of
carrier assembly and surface of floor jack.
This will keep carrier assembly off floor jack
for easier removal of the differential from the
Capscrews and washers
Remove twenty-four capscrews and washers.
Two 3/4-10NC forcing screws
Tighten evenly to loosen differential.