FRONT DIFFERENTIAL AND BEVEL GEAR INSTALLATION (CONT)
(Sheet 3 of 4)
Hydraulic lines and manifold that
attach to differential
Secure with the two capscrews (4).
Brake tube assembly (5)
a. Connect to wheel.
Install clip (6) that holds tube assembly
to axle housing.
Remove air (bleed).
Position flat on wood blocks.
Remove blocks from around rear tires.
Keep away from vehicle when mast is used
to raise and/or lower front end.
Lower mast until front end of machine
is raised enough to remove wood blocks
under front tires.
Lower front end back to ground.
Go on to Sheet 4