TM 10-3930-641-34-2
DRIVE SHAFTS DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 10 of 15)
LOCATION/ITEM
ACTION
REMARKS
7.
Seal (13)
a. Install in cage using suitable seal driver.
Seal must contact counterbore in cage.
Seal lip must face away from cage.
b. Put GAA Grease on lip of seal.
8.
Bearing (18)
Install in flanged side of cage.
9.
Bearing cage retainer (22)
Align on cage without seal or shims.
10.
Three of six capscrews (23)
a. Install, evenly spaced. Tighten evenly to a
torque of 65 to 85 lb. ft. (88 to 115 N'm).
b. Loosen capscrews.
c. Tighten capscrews again, finger tight only.
TA099441
Go on to Sheet 11
4-317