TM 10-3930-641-34-2
(Sheet 4 of 6)
LOCATION/ITEM
ACTION
REMARKS
8.
Shims (4)
Install enough so that the thickness is .005 in.
(0.13 mm) less than the distance in step no. 7.
9.
Ring (3)
a. Install with capscrews (2).
b. Tighten capscrews evenly to a torque of
180 to 220 lb. ft. (245 to 305 N-m).
NOTE
ADJUSTMENT PROCEDURE
(ON THE VEHICLE)
These adjustments start with sections of the
equipment on the vehicle.
1.
Wheel assembly (1) and bearings Put on spindle housing (7).
2.
Hub (5) and ring gear (8)
Install.
3.
Ring (3) without shims
Install.
4.
Two capscrews
a. Install so that they are opposite each other.
b. While turning wheel by hand, tighten
evenly to a torque of 35 to 45 lb. ft.
(48 to 62 Nm).
Go on to Sheet 5
5-94