ARTICULATED HITCH DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 9 of 16 )
Install in upper bearing cup (21) of lower pivot
joint using a seal installation tool and hammer
Install seal so lip is toward outside of bearing
cap and makes contact with counterbore.
Other seal (22)
Install in lower bearing cup (21) of lower pivot
Install seal until it makes contact with counter-
bore. Lip of seal must be toward inside of cap.
Lower cap (23)
Install in lower pivot joint.
Lower bearing cup (21)
Lower temperature to -900 to -110F
(-32.1 to -430C) and install in the bore.
Use to make bearing cup contact lower cap.
Two bearing cones (20)
Install in bore of lower pivot joint.
Go on to Sheet 10