HYDRAULIC (STEERING AND BRAKE) PUMP DISASSEMBLY/ASSEMBLY (CONT)
(Sheet 8 of 10)
Pressure plate (20)
Pressure plate must be installed with machined
notch (trap slot) toward outlet side of pump
and bronze side toward gears.
Isolation plate (25)
Install on inlet side of pump.
Back-up ring (18)
Ring retainer (17)
Install beveled side up.
Install in flange (6).
Body assembly (11)
Position on pump body and install nuts.
Tighten nuts to a torque of 165 lb. ft. to 185
lb. ft. (223.7-250.8 N.m).
Lip seals (3) and (1) and spacer (2)
Install in flange with a seal driver.
Install outside seal with lip toward outside of
Go on to Sheet 9