STEERING CYLINDERS REMOVAL/INSTALLATION (CONT)
(Sheet 3 of 6)
a. Start engine and turn steering wheel until
rod is positioned all the way into cylinder.
Shut off engine.
Hydraulic lines at steering cylinder
Tag and disconnect. Use plugs in openings to
keep dirt out.
Fasten hoist and sling.
Lubrication line (4)
Disconnect from steering cylinder.
Capscrew and washer installed in
Remove from cylinder end retaining pin.
Tool Install as follows:
a. Washer (A)
a. Place on pin.
b. Capscrews (2)
b. Install in pin (3).
c. Jacking cylinder (B)
c. Install under pin, against capscrew.
Go on to Sheet 4