HYDRAULIC PUMP REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 8)
Precleaner lid (1) and hood (2)
Remove. See TM 10-3930-641-20.
Door assemblies at rear of engine Open.
Hydraulic lines (3)
Tag and disconnect from oil filter base
Wires for sending units of trans-
Disconnect from harness (4) and identify.
mission and brake system oil
5. Six capscrews (5) that hold bases Remove.
for brake and transmission oil filters
Do not disconnect hydraulic lines from the
filter bases. Place filters and bases on floor
Go on to Sheet 4