CAB WINDOW CLASS REMOVAL/INSTALLATION (CONT)
(Sheet 2 of 3)
Remove windshield wiper and arm. See
a. Place seal installation tool (A) between two
locking lips (6) of seal (1).
b. Move tool (A) along seal pulling locking lip
out and away from cab.
Move the tool (A) completely around seal.
Remove glass from seal.
Remove seal from opening in panel.
a. Install groove (4) of seal (1) over edge of
panel (5) with locking lip (6) toward out-
side of cab and nearer the glass (7) than
b. Install seal (1) all around edge of opening.
Cut seal so end will extend past the starting
point by .125 in. (3.18 mm) per foot. This
will make a tight waterproof seal.
Push ends together.
Go on to Sheet 3