PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) INTRODUCTION - CONTINUED
GENERAL LUBRICATION PROCEDURES
Lubrication instructions contained in this PMCS are mandatory.
Overall views of lubrications points are located at the end of this work package.
Refer to FM 9-207 for lubrication in arctic operation.
Included in this PMCS are lubrication services to be performed by the operator.
Lubrication intervals are based on normal operation. Lubricate more during constant use and less during inactive peri-
ods. Use correct grade of lubricant for seasonal temperature expected. Refer to KEY on page 0012 00-4.
For equipment under manufacturer's warranty, hardtime intervals shall be followed. Shorten intervals if lubricants are
known to be contaminated or if operation is under adverse conditions (e.g., longer than usual operating hours, extended
idling periods, extreme dust, etc.).
Keep all lubricants in an environmental storage container and store in a clean, dry place away from extreme heat. Keep
container covers clean and do not allow dust, dirt, or other foreign material to mix with lubricants. Keep lubrication
equipment clean and ready for use. Clean top of container before opening.
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
cause injury or death to personnel.
Clean area around lubrication points with Solvent, Dry Cleaning, Type III (Item 13, WP 0019 00) or equivalent before
lubricating equipment. Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrica-
tion, wipe off excess lubricant to prevent accumulation of foreign matter.
Maintain a record of lubrication performed and report any problems noted during lubrication. Refer to DA PAM 750-8
for forms and procedures to record and report any findings.
Man-Hour Times. The man-hour time specified is the time needed to perform all services prescribed for a particular
interval. The man-hour times for the RTCH are as follows: