ENGINE SENSORS REPLACEMENT - CONTINUED
INTAKE MANIFOLD PRESSURE SENSOR REMOVAL - CONTINUED
INTAKE MANIFOLD PRESSURE SENSOR INSTALLATION
Install new o-ring seal (16) on intake manifold pressure sensor (17).
Install intake manifold pressure sensor (17) on intake manifold (14). Tighten sensor to 120 lb-in (14 Nm).
Ensure locking tab on connector snaps in place.
Connect connector (15) of engine wiring harness (2) to intake manifold pressure sensor (17).
Install engine cover (WP 0143 00).
FUEL INLET RESTRICTION SENSOR REPLACEMENT
The fuel inlet restriction sensor is located on the fuel pump filter head. It is replaced in the same manner as
the intake manifold pressure sensor.
AMBIENT AIR PRESSURE SENSOR REPLACEMENT
The ambient air pressure sensor is located on bracket on left side of engine to right-rear of engine ECU. It is
replaced in the same manner as the intake manifold pressure sensor.