BRAKE COOLING FILTER AND FILTER HEAD REPLACEMENT - CONTINUED
BRAKE COOLING FILTER REMOVAL
Two brake cooling filters are installed on vehicle: one at front and one at rear. Both are replaced in a similar
manner. Front brake cooling filter is detailed below.
Position suitable container to catch hydraulic oil from lines.
Use a filter strap wrench to loosen brake cooling filter (1) and remove from filter head (3) by hand. Discard filter.
BRAKE COOLING FILTER INSTALLATION
Ensure filter head mating surface is clean and free of residue.
Apply a coat of lubricating oil to brake cooling filter seal (2) and fill filter with clean lubricating oil.
Install new brake cooling filter (1) on filter head (3) and tighten by hand.
Use a strap wrench to tighten brake cooling filter (1) an additional ½ to ¾ turn.
Check hydraulic oil level and add oil as needed (LO 10-3930-675-12).
Start engine (TM 10-3930-675-10) and check for leaks.