TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
STYLE A WEAR PLATE REMOVAL - CONTINUED
Measure wear plate thickness. Measurement MUST be a minimum of 1 in (25.4 mm). If wear plate is not as specified,
replace wear plate.
STYLE A WEAR PLATE INSTALLATION
Measure thickness of shims (6) removed from wear plate location. Shim measurement MUST NOT exceed 0.25 in (6.4
mm). Remove shims as necessary so as not to exceed requirement.
Total thickness of wear plate and shims for style A location must not exceed 1.25 in (31.8 mm).
Install wear plate (5) and shims (6) as needed in sliding carriage frame (4).
Position cover (3) and secure in place with six screws (1) and washers (2). Tighten screws in accordance with Torque
Limits (WP 0198 00).
Perform operational check of tophandler (TM-10-3930-675-10).