TM 10-3930-675-24-1
ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED
0009 00
Table 2. Error Code 1132 - Low Voltage Detected at Throttle Position
Sensor Circuit Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1132 - Low Voltage Detected at 8. Inspect pins. Remove the a. Clean and repair connector as
Throttle Position Sensor Circuit - Continued.
engine cover (WP 0148 00).
required (WP 0113 00).
Disconnect the OEM harness b. Replace damaged ECU (794)
connector from ECU (794)
(WP 0080 00).
(WP 0080 00). Inspect the
OEM harness connector and
ECU pins for damage, dirt, or
corrosion.
9. Check
for
continuity.
If continuity to ground is found at
Disconnect connector X16 and
any one wire or any wire is found
the OEM harness connector.
to be open, replace engine and
Check continuity and for
transmission wiring harness (WP
continuity to ground for wires
0113 00).
00-11).
10.Check
for
Disconnect connector X16 and
connector (WP 0113 00).
inspect for damage. Check b. Replace any damaged, open or
grounded wires.
ground for wires A163, A164,
434-40014
0009 00-11