TM 10-3930-675-24-2
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) INTRODUCTION - CONTINUED
0050 00
GENERAL LUBRICATION PROCEDURES - CONTINUED
NOTE
DO NOT lubricate boom and tophandler wear plates.
Initial Break-in. Perform the following after the first 100 to 200 hours of operation:
Change transmission fluid.
Change transmission filters.
Remove, clean, and reinstall transmission internal coarse filter.
Check oil level in front/rear axle differential housings.
Check oil level in front/rear axle differential housings.
Check oil level in front/rear axle hub ends.
Clean and lubricate boom support locking pins.
Drain and refill tophandler spreader and slewing motors.
Man-Hour Times. The man-hour time specified is the time needed to perform all services prescribed for a particular
interval. The man-hour times for the RTCH are as follows:
Interval
Man-Hour
Daily
0.5
Weekly
0.5
300 Hours
3.0
900 Hours
4.0
0050 00-4