TM 10-3930-675-24-2
BOOM ANGLE SENSOR REPLACEMENT - CONTINUED
0099 00
REMOVAL - CONTINUED
4.
Loosen four screws (11) and remove cover (10) from junction box (12), located on right side of boom. Inspect rubber
seal in groove of cover. Replace seal only if damaged.
10
11
12
5.
Loosen cable nut (15) and slide cable nut, grommet (16), and bushing (17) back on cable (14) of boom angle sensor (4).
CAUTION
To avoid damage to junction box, a fine-tipped jeweler's screwdriver should be used when disconnect-
ing wires. DO NOT use a punch.
NOTE
Tag wires for installation.
6.
Using a jeweler's screwdriver, disconnect three wires of cable (14) from terminal blocks (13) of junction box (12).
NOTE
Remove tiedown straps as needed. Discard tiedown straps.
7.
Remove boom angle sensor (4) with cable (14) from vehicle.
0099 00-2