STEERING SYSTEM HYDRAULIC HOSES AND FITTINGS REPLACEMENT - CONTINUED
Close hydraulic reservoir ball valve (25) (refer to foldout, FO-3).
Using illustration (foldout, FO-3) as a guide, remove damaged hose(s) or fitting(s). Cap or plug openings.
Note position of tiedown straps and clamps to aid in installation.
Remove tiedown strap(s) and clamp(s) (if applicable). Discard tiedown strap(s).
Discard O-ring(s) removed.
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
Lubricate and install new O-ring(s).
Remove caps/plugs and install and tighten hose(s) or fitting(s).
Install clamp(s) and new tiedown strap(s) (if applicable) in same position as noted during removal.
Open hydraulic reservoir ball valve (25).
Start engine (TM 10-3930-675-10), operate steering, and check for leaks.
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE