TM 10-3930-675-24-2
CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
0138 00
CAB ADJUSTMENT: OPERATIONAL POSITION - CONTINUED
20.
Tap left-side receptacles (24) in place to receive cab pins (28). Ensure receptacles (24) are as level as possible and insert
pin (28) into hole to center receptacles as closely as possible.
21.
Slowly move cab to transport position. Tighten receptacle bolts (27) and nuts (25) to 180 lb-ft (244 Nm).
24
29
25,26
434-40117
22.
Move cab back and forth several times to check pin alignment and proper operation.
23.
CAB ADJUSTMENT: TRANSPORT POSITION
WARNING
DO NOT perform maintenance under cab when it is elevated on the cab transport lift. Fully move the
cab to the operational position when the procedure indicates a cab movement. Failure to follow this
warning may result in injury or death to personnel.
CAUTION
Always move cab slowly between operational and transport positions to prevent moving recepta-
cles out of position.
Damage to the proximity switch can occur if it projects beyond the proximity switch guard.
NOTE
The switch should be located approximately 0.039 in. (1 mm) inside proximity switch guard.
1.
Move cab to transport position. Activate cab side movement control right until cab stops.
0138 00-7