TM 10-3930-675-24-2
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0147 00
STYLE B WEAR PLATE REMOVAL
NOTE
Style B wear plates use the same hardware. For removal procedures, refer to step 1 below.
Access procedures and requirements for each location are different. Refer to steps 2 and 3 for spe-
cific access procedures.
1.
To remove a style B wear plate mounted on sideshift carriage frame:
a.
Remove four screws (10) and washers (11) securing mounting plate (12), backing plate (13), and frame (15) to
sideshift carriage frame (9).
b.
Remove screw (7) and washer (8) securing wear plate (14).
9
10,11
12,13
14,15
7,8
10,11
c.
Remove spacer (12), spacer (13), frame (15), and wear plate (14).
d.
Measure thickness of wear plate (14). Measurement must not be less than 0.5 in. (13 mm).
e.
If measurement is more than 0.5 in. (12.7 mm), but less than 1 in. (25.4 mm), add backing plates (13) as needed.
0147 00-6