TM 10-3930-675-24-2
FENDER ASSEMBLY REPLACEMENT (ARMY, RESET, AND USMC) - CONTINUED
0149 00
FENDERS AND FENDER BRACKETS INSTALLATION (ARMY)
NOTE
Perform steps 1 thru 3 to install fender support bracket on vehicle.
1.
Install fender support bracket (1) on vehicle with eight new lockwashers (15) and screws (14).
2.
Install light bracket (9) on fender support bracket (1) with eight washers (8), four screws (7), and new locknuts (6).
NOTE
During installation of the wiring harness, allow a loop in the harness at the base of the fender support
bracket to allow the wheel to turn without damaging the harness.
3.
Install wiring harness (5) on fender support bracket (1) with nine clamps (4), washers (3), and screws (2).
NOTE
Perform steps 4 and 5 to install fender on fender support bracket.
4.
Position fender (10) on fender support bracket (1).
5.
Install fender (10) on fender support bracket (1) with twelve washers (13), six screws (12), and new locknuts (11) at
front and rear of fender.
FRONT FENDERS AND FENDER BRACKETS REMOVAL (RESET)
WARNING
DO NOT perform this task without first relieving steering hydraulic system pressure. When working
in close proximity to wheels and tires, safety dictates that there be no danger of inadvertent movement
in wheels and tires. Failure to relieve steering hydraulic system pressure could result in injury to per-
sonnel.
1.
At rear of fender, remove six locknuts (2), six screws (3), and twelve washers (4).
2.
At front of fender, remove three locknuts (5), three screws (6), and six washers (7).
3.
Remove fender (1) from fender bracket (10).
5,6,7
2,3,4
1
434-40180
0149 00-4