HYDRAULIC SYSTEM COOLING HOSES AND FITTINGS REPLACEMENT - CONTINUED
This work package covers replacement of hydraulic hoses and fittings that support the following
hydraulic system components:
engine-driven hydraulic pump
front and rear service brake cooling lines
Tag all hydraulic lines.
Using appropriate illustration (refer to foldouts, FO-4 and FO-5) as a guide, remove damaged hose(s) or fitting(s). Cap
or plug openings.
Note position of tiedown straps and clamps to aid in installation.
Remove tiedown strap(s) and clamp(s) (if applicable). Discard tiedown straps.
Discard O-ring(s) removed.
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
Lubricate and install new O-ring(s).
Remove caps/plugs and install and tighten hose(s) or fitting(s).
Install clamp(s) and new tiedown strap(s) (if applicable) in same position as noted during removal.
Start engine (TM 10-3930-675-10) and check for leaks.
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE