MAIN HYDRAULIC SYSTEM HOSES AND FITTINGS REPLACEMENT - CONTINUED
Using illustration (refer to foldout, FO-7 at the end of this manual) as a guide, remove damaged hose(s) or fitting(s). Cap
or plug openings.
Note position of tiedown straps and clamps to aid in installation.
Remove tiedown strap(s) and clamp(s) (if applicable). Discard tiedown strap(s).
Remove and discard O-ring(s).
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
Lubricate and install new O-ring(s).
Remove caps/plugs and install and tighten hose(s) or fitting(s).
Install clamp(s) and new tiedown strap(s) (if applicable) in same position as noted during removal.
Open any ball valve at hydraulic reservoir that was closed.
Start engine (TM 10-3930-675-10) and check for leaks.
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE