TM 10-3930-675-24-2
TOPHANDLER WIRING HARNESSES REPLACEMENT - CONTINUED
0221 00
WIRING HARNESS D, JUNCTION BOX 182-TO-JUNCTION BOX 183: REMOVAL
1.
Loosen four screws (5) and remove cover (4) from junction box 182 (6). Inspect rubber seal in groove of cover. Replace
only if damaged.
4
5
6
2.
Remove retainer nut (22), grommet (23), and sleeve (24).
NOTE
Use wiring diagrams in WP 0048 00, as needed, and note terminal block numbers to wire lead num-
bers for installation.
3.
Using jeweler's screwdriver, disconnect wiring harness D (25) leads from junction box 182 (6) terminal block (8).
Remove harness from junction box.
6
8
25
22,23,24
0221 00-10