TM 10-3930-675-24-2
BRAKE AND STEERING ACCUMULATOR SERVICE - CONTINUED
0231 00
BRAKE ACCUMULATOR CHARGING
1.
Remove cap (2) from valve end of brake accumulator (1). Remove plug (3).
1
2
2.
Remove plug (3) and connect hose assembly of nitrogen charging kit to valve (4).
3.
Open nitrogen tank valve.
4.
Slowly open pressure regulator valve.
5.
Charge accumulator with nitrogen until pressure reading on low pressure gage is 1,305 psi (90 bar). Bleed off excess
pressure using bleeder valve, then close pressure regulator valve.
6.
Close nitrogen tank valve.
7.
Disconnect hose assembly of nitrogen charging kit from valve (4). Install plug (3).
8.
Install cap (2) on valve end of brake accumulator (1).
9.
Perform a soapsuds leak check at valve end of brake accumulator (1).
0231 00-3