TM 10-3930-675-24-2
STEERING CALIBRATION - CONTINUED
0238 00
CALIBRATION - CONTINUED
9.
Steering System Hydraulic and Electrical Connections Check (Menu 8 of 10).
a.
Pressing value increase "+" button will result in wheel no. 4 (LF) moving right and an increase of values on ECS
display screen.
b.
Pressing value decrease "-" button will result in wheel no. 4 moving left and a decrease of values on ECS display
screen. ECS display screen should look as shown:
CALIBR STEERING
8 (10)
AXLE 4
Range 0 +/-5
ADJUST WHEEL
0
ANGLE
0
c.
Press right arrow button to advance through remaining steering system calibration menus.
Steering Cylinder No. 4 Calibration (Menu 9 of 10).
10.
a.
Steering cylinder position must be manually checked by measuring cylinder length. Measurement should be taken
from center-to-center of cylinder mounting pins. Correct length is 31 5/16 in. (796 mm). If length is incorrect,
adjust steering cylinder for wheel no. 4 (LF) by pressing increase "+" or decrease "-" buttons.
b.
Press "Enter".
c.
Recheck steering cylinder position. Correct length should be 31 5/16 in. (796 mm).
d.
ECS display screen should look as shown:
CALIBR STEERING
9 (10)
AXLE 4
SET WHEEL
0
ANGLE
0
e.
Press right arrow button to advance to remaining steering system calibration menu.
Calibration of Steering System Completed (Menu 10 of 10).
11.
a.
With all calibration steps complete and corrections or adjustments made, press "Enter" to return to main menu.
b.
ECS display screen should look as shown:
CALIBR STEERING
10 (10)
CALIBRATION OF
STEERING DONE
ENTER
12.
Turn off engine and restart to save data.
END OF WORK PACKAGE
0238 00-4