TM 10-3930-675-24-2
BOOM ASSEMBLY REPLACEMENT - CONTINUED
0258 00
INSTALLATION - CONTINUED
CAUTION
Use caution when lifting boom assembly. Ensure boom assembly clears vehicle and does not contact
electrical or hydraulic components. Failure to follow this caution may cause damage to components on
boom assembly or damage to vehicle.
3.
Lift boom assembly and position at vehicle.
4.
Lower boom assembly (8) and position into boom support (9), while aligning pivot shaft holes in boom assembly with
holes in boom support.
NOTE
Ensure pivot shafts are clean and free of burrs.
When installing pivot shafts, slot in pivot shaft for retaining screw must be aligned with screw
hole in boom assembly.
Covers may be removed to aid in alignment of pivot shafts.
5.
Install pivot shaft (10) on each side of boom support (9). Secure with new lockwasher (12) and screw (11).
8
COVER
MEASURE
CENTER OF
GRAVITY
FORWARD
FROM THIS
POINT
11,12
10
9
6.
7.
Remove lifting device from boom assembly (8).
8.
0258 00-5