TM 10-3930-675-24-2
FORKLIFT CYLINDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Direct Support
Tools and Special Tools
Tool Kit, General Mechanic's (Item 128, WP 0289
Personnel Required
Two
References
Materials/Parts
Grease, Automotive and Artillery, GAA (Item 20,
Equipment Condition
Oil, Lubricating, OE/HDO 10 (Item 26, WP 0290
Forklift removed from tophandler (TM 10-3930-
675-10)
WARNING
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting
any hydraulic lines. Failure to do so could result in injury.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
Use extreme caution when handling heavy parts. Provide adequate support and use assistance
during procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this warning
may result in death or injury to personnel.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings
after disconnecting. Contamination of hydraulic system could result in equipment failure.
NOTE
Forklift cylinders are replaced in the same manner.
Tag all hydraulic lines.