TM 10-3930-675-24-2
HYDRAULIC SYSTEM VALVE MAINTENANCE - CONTINUED
0263 00
PUMP SHUT-OFF VALVE (611) REMOVAL - CONTINUED
5.
Remove two fittings (2) from valve (5).
8,9,10
2
3,4
1
5
6
434-40197
434-40196
7
11
PUMP SHUT-OFF VALVE (611) INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
Perform step 1 to install fittings removed from old valve, if a new valve is being installed.
1.
Install two fittings (2) on valve (5).
2.
Lubricate and install two new O-rings (4).
3.
Install two hoses (3) on valve (5).
4.
Install two valves (5 and 1) on mounting plate (6) with two bolts (8), washers (10), and nuts (9). Tighten bolts to specifi-
5.
Connect electrical leads (11) to valve solenoid (7).
6.
Install clamps and new tiedown straps as needed, in same position as noted during removal.
7.
At hydraulic reservoir, open any ball valve that may have been closed.
8.
9.
Start engine (TM 10-3930-675-10) and check for leaks.
0263 00-3