TM 10-3930-675-24-2
CYLINDER BLOCK REPAIR - CONTINUED
0271 00
ASSEMBLY - CONTINUED
NOTE
Each cylinder liner must be checked for out-of-roundness and cylinder liner-to-block clearance after
being installed in cylinder block.
4.
Measure cylinder liner out-of-roundness as follows:
a.
Measure cylinder liner at points "C", "D", "E", "F", and "G".
b.
Measure each point in direction "AA" and "BB".
c.
Bore MUST NOT be more than 0.004 in. (0.10 mm) out-of-round.
CYLINDER LINER OUT-OF-ROUND
5.
Using thickness gage, measure cylinder liner-to-block clearance. Measurement must be 0.10 in. (0.25 mm). If measure-
ment is less than specified, remove and reinstall liner.
CYLINDER LINER-TO-BLOCK CLEARANCE
0271 00-12