b. Remove and discard packing seal (7).
a. Install new seal (6) into rear seal cover (4).
If oil pan has not been removed, remove four
b. Mount rear seal cover (4) and new gasket (5)
capscrews attaching oil pan to rear seal cover
with six capscrews (3).
Position new packing seal (7) on seal cover (4)
d. Remove six capscrews (3) from rear seal cover
and lubricate with Lubriplate 105.
(4) and remove with gasket (5).
2. INSTALL REAR SEAL (6) (COVER INSTALLED).
e. Drive out and discard seal (6) from rear seal
2. REMOVE REAR SEAL (6) FROM SEAL COVER (4).
a. Drill two 1/8 in. holes 180 degrees apart in seal
b. Install slide hammer with No. 10 sheet metal
screw into holes and remove seal (6).
1. INSTALL REAR SEAL (6) (COVER