TM 5-3810-306-34
a. Clean and dry crankshaft sealing surface.
5. INSTALL STARTER. (REFER TO TM 5-3810-306-
20.)
b. Install seal pilot from seal kit, over crankshaft.
Push new seal (6) over pilot, into position.
6.
(REFER TO
Remove pilot.
c.
Tap seal with alignment tool until tool stops
against housing
8. INSTALL ENGINE HOOD. (REFER TO TM 5-3810-
3. INSTALL FLYWHEEL HOUSING (1).
306-20.)
9. CONNECT NEGATIVE BATTERY CABLE
AT
CAUTION
SHUNT. (REFER TO TM 5-3810-306-20.)
Make sure flywheel housing is
END OF TASK
positioned onto the alignment dowels
and packing seal (7) is not cut or
damaged.
a. Mount flywheel housing (1) with twelve
capscrews (2). Torque capscrews (2) to 45 ft-
lbs (60 Nm) in sequence shown.
4-31