h. Look for timing pin hole in camshaft gear
by looking through timing pin assembly
hole in front gear cover. If it is not visible,
rotate the crankshaft one complete turn.
i. Remove wire pointer (9) and vibration
2. INSTALL TIMING PIN ASSEMBLY (2).
a. Install new gasket (3), timing pin assembly
(2) and torx screws (1). Do not tighten
b. Push pin (5) into hole in cam gear to align
c. Hold pin (5) in and torque torx screws (1)
to 4 ft-lbs (5 Nm).
3. CONNECT NEGATIVE BATTERY CABLE AT
SHUNT. (Refer to TM 5-3810-306-20.)
END OF TASK