TM 5-3810-306-34
ring gear screw tapped holes with solvent. Dry
INSTALLATION
thoroughly, being certain ring gear screw holes
are dry and clean.
NOTE
b. Install torque converter ring gear (3) as shown.
The
torque
converter
weighs
approximately 267.50 pounds (121.34
NOTE
kg) dry.
Apply Loctite #242 to mounting bolts (5).
1. IF NEW CONVERTER IS TO BE INSTALLED,
ENSURE ALL COMPONENTS FROM OLD ONE
NOTE
ARE INSTALLED ON NEW ONE.
Assembly of ring gear must be
2. INSTALL PUMP DISCONNECT (9), IF REMOVED,
completed within a fifteen minute
AND BOTH HYDRAULIC PUMPS (7) AND (8).
period
from
start
of
screw
installation.
3. IF REMOVED, INSTALL RING GEAR (3) ON
FLYWHEEL (4).
a. Remove all burrs from flywheel mounting face
and pilot bores. Clean torque converter ring
gear flywheel mounting surface and
7-3