TM 5-3810-306-34
INSPECTION:
1.
INSPECT BEARINGS.
b. Inspect gear teeth for wear, pits, nicks, cracks
and scores. Replace gear(s) if hardening is is
a. Inspect all bearings, cages and cups for wear,
worn or cracked. Remove minor damage with
nicks and chips.
suitable hone.
c. Inspect all shafts, insuring each is true, not
NOTE
sprung or bent.
Bearing cones and cups are matched
3.
INSPECT HOUSINGS AND COVERS.
sets. Replace both if one is bad.
a. Inspect all mating surfaces for nicks and burrs.
b. Dip cleaned bearings in clean oil MIL-L-21-4
SAE 10.
b. Inspect all parts for cracks and damage.
c. Wrap each clean and lubed bearing in a clean,
c. Ensure all parts are clean.
lint-free cloth until installed.
2.
INSPECT ALL GEARS AND SHAFTS.
a. Using a Magna-flux process, inspect all gears
and shafts for damage and cracks.
7-41/7-42 Blank