Section II. DIFFERENTIAL MAINTENANCE
Yoke three-piece installation tool (Item 10, Appendix C)
Axle propeller shafts removed. (Refer to TM 5-3810-306-20.)
Propeller (drive) shaft disconnected. (Refer to TM 5-3810-306-20.)
b. Break differential carrier loose from axle
housing using rawhide mallet.
1. DRAIN GEAR OIL.
c. Place roller jack under differential carrier
a. Place suitable container under axle drain
d. Remove remaining two nuts (41) and
b. Remove drain plug (40).
2. REMOVE DIFFERENTIAL CARRIER.
Use rounded pry bar to prevent
damage to housing (31).
Loosen two top nuts (41) but do not
e. Work differential carrier free. A small pry
remove them. Otherwise differential
bar can be used to straighten housing (31)
carrier could fall.
in axle housing bore.
a. Remove nuts (41) and washers (42).